WELCOME TO EKSTER SUPPORT
All articles

User Manual - Key HolderUpdated 2 years ago

The Ekster Key Holder is our innovative solution to every-day keyrings. Keys are organized in a compact, silent stack with magnetic add-ons for larger keys, like car keys. Check out the video below to see how it works. 

Set Up:

  1. Remove the assembly screw from the top of Key Holder to seperate the two arms.
  2. You will see that one arm has a smaller pole, this slides inside the larger one so it is important to only place keys on the side with the larger pole.
  3. Begin by placing one metal spacer on the larger pole.
  4. Now you can add keys, but make sure to place a rubber spacer between each key.
  5. Once all keys are added, place the second metal spacer on top of the stack and slide in the smaller arm.
  6. Attach the slider bolt and insert the magnetic screw. Squeeze the arms together firmly while tightening the magnetic screw fully.
  7. Now you can attach the magnetic add on and quick release ring.

Features and Specifications

  • Capacity: Up to 8 standard keys, or 6 with Key Tracker
  • Suitable for keys with >4 mm keyhole
  • Suitable for RFID key
  • Magnetic add-on for extra keys
  • 32.5 x 16 x 9.6 mm (without Key Tracker)

FAQs:

What is the Key Holder?
  • The Ekster Key Holder is a compact key organizer keeping all your keys in a silent stack. It keeps them streamlined and easy to use.
How many keys will fit inside?
  • The Key Holder's extendable bodies make them a perfect fit for storing up to 8 keys, or up to 6 when paired with the Key Tracker.
What sized keys should it hold? 
  • Most keys will fit without any issue, as long as:
    • The hole on your key is greater than 4mm in diameter
    • It has a flat profile
    • The length is shorter than 67mm (from the hole to the end of the key).
  • This also applies to keys with irregularly-shaped holes (e.g. slot, square, triangular).
Can I add extra keys?
  • Yes, the Key Holder comes with a magnetic add-on that lets you attach extras such as your car keys.
The keys are loose, how can I prevent this? 
  • You need at least 3 keys in the Key Holder to ensure nothing falls out. Use the silicone spacers between each key, and make sure the Key Holder has metal washers between each of the metal arms framing the keys. Make sure to press the Key Holder tight against the keys inside to avoid any extra wiggle room and to make your keys as secure as possible.
Is the Key Tracker included? 
  • The Key Holder and the Key Tracker are two different products, so it is not included. However, you can add it to your cart when placing your order for the Key Holder.
What is the Key Holder made of? 
  • The Key Holder is made of stainless steel to ensure durability, and keep it light to carry.


WARNING: CHOKING HAZARD – Key Holder contains small parts. Not suitable for children under 3 years.

Was this article helpful?
Yes
No